Pipe Flange Aligner

Model #38240
This model features slotted pins with "friction-fitting" knurled nuts for flanges to 30" - 150 lbs (2-1/2" thick). Fits flanges with holes 1/2" to 1 7/16" diameter. One pin has a vial for easier vertical leveling.

Model #38240-T
This model has threaded pins for flanges to 30" - 150 lbs (2-1/2" thick). Fits flanges with holes 1/2" to 1 7/16" diameter. One pin has a vial for easier vertical leveling.

Model #38240-TL
This is our largest set of threaded pins for flanges 48" – 150 lbs (4" thick) with holes up to 1 15/16" in diameter, One pin has a vial for easier vertical leveling.

All of the above models of the Pipe Aligner will two-hole (make 2 holes of the flange horizontally level with the ground) and vertically level the face of the flange in ONE easy step

The Pipe Flange Aligner saves valuable fit-up time, in most cases it cuts fit-up time in half and eliminates the frustration of balancing a level on the pins.

All models now come with 360 degree vials that just "snap" in and out for easy replacement.
.

.